Description:

• This machine is still set up and available for demonstration
• PC-20 program controller with 256mb of ram, 1gb flash card, 12" screen, USB port and remote diagnostic link
• .4 to 15mm edge thickness
• 2 3/8" maximum panel thickness
• 6 3/8" minimum panel length
• 2 3/8" minimum panel width
• Machine has line control with no limit switches for workstation timing
• Pressure beam height adjustment with digital height indicator
• Light signal to schedule in-feed spacing of panels
• 2 X 3hp 12,000RPM pre-mill with program controlled indexing from straight to bevel
• Quick (10min) heat up glue system with quick change pot for glue color changing and maintenance
• LED glue temperature indicators for glue pot and application roller
• Automatic glue temperature reduction if inactive for 15 minutes
• Reversible and retractable glue application roller
• 800mm diameter support table for 3mm edging and automatic strip feeding
• Heavy duty guillotine for 3mm PVC
• 1 driven and 3 idle pneumatically controlled pressure rollers
• 2 X 1/2hp 12,000rpm end trim saws that adjust under program control from 0 degrees to 15 degrees
• Top and bottom 3/4hp 12,000rpm rough trim heads with insert knives for 3mm pvc
• Top and bottom 3/4hp 12,000rpm fine trim heads with servo motor controlled positioning. Horizontal and vertical tracing wheels. Heads bevel from 0 degrees to 15 degrees with insert knives for 3mm pvc
• 2 X 1/2hp 12,000rpm corner rounding heads for front and trailing corners
• Top and bottom 3mm radius scrapers with pneumatically controlled indexing
• Top and bottom excess glue scrapers
• Top and bottom 1/4hp 2,800rpm oscillating buffers
• 3hp variable feed motor from 36 to 65fpm
• Corner rounding is done at 52fpm
• 12,000rpm heads have high frequency motors with electronic brakes
• Operation control panel with PLC, key pad and LED readouts