Description:

• A 53" (1,350mm) wide belt finishing sander with 3 electronic segmented heads.
• Max 110mm (4.3") min 3mm (1/10") work piece thickness.
• Automatic work piece thickness adjustment.
• Independent 2 speed rise and fall on all heads.
• Fixed pass height at 900mm.
• Electronically controlled sanding belt oscillation'
• "Hydra 2" monitor with individual programming for each sanding head.
• Individual timing anti-dubbing adjustments to avoid leading and trailing edge sand through.
• Thickness adjustment memory.
• Safety stop in case of damaged sanding belt.
• Support rollers at the in-feed and out-feed ends of feed belt.
• Emergency stop at rear of the machine.
• Tracking and tension adjustments for feed belt.
• Feed from 4,5 to 21m/m (15 to 69 ft/m) by 4HP feed motor.
• Vacuum part hold down on feed belt by 10HP sound enclosed vacuum fan.
• Hour counter.
• Rapid deceleration of sanding belts.
• Low air consumption dust extraction.
• HEAD #1 is a combi unit with rubber roller and/or 48 independent pneumatic cylinder electronic segments working.
• Sanding pressure controlled from control panel.
• Rapid change for graphite segments.
• Automatic disc brake.
• Rubber pressure roller.
• 25HP 2 speed belt rotation motor (7 or 14 m/sec 23 or 46 ft/sec).
• Belt length 2620mm (103").
• Belt width 1400mm (55").
• HEAD #2 and #3 are as per head #1 except not Kombi heads and with 20HP and 15HP respectively.
• Head #2 has reversible belt rotation for working lifting grain.
•  Head #3 has variable rotation speed from 3 to 18m/sec (10 to 59 ft/sec).
• 140mm TAMPICO panel cleaning brush at out-feed with 1HP motor.
• Timed belt cleaning blowers on all belts