Heeseman DBV 2-0 U

Fully automatic dual-band grinding machine
Type DBV 2-O / U

working simultaneously from above and below

Large pieces of 600 mm width
this machine in one pass from top
and bottom of the edited pre-and regrinding.
DBV 2-O / U is used for grinding
from both sides veneered panels of chipboard
panels, raw or with a spatula and Order of
Doors and window frames.

In a compact design ever have two grinding units
above and below a specific transport
bed arranged with driven rollers. By
constant working height of 880 mm, the
Machine for integration into processing lines.
The overhead aggregates on gear
motor in the amount of movable workpiece thickness
of 6-80 mm, in the special case for greater strength-
dimensions. The operating speed is in the range of
6-30 m / min. infinitely variable.

The grinding units correspond in structure and
Function to the design principle of the machine
DBV second Adaptability to the height of workpiece
surfaces is achieved by elastic seals.
The grinding pressure is precisely controlled. Separately
driven, as a slower speed
the slip bands encircling pressure segment tapes,
is a dynamic attack and an abrasive effect
just achieved moderate sanding. The slip-band
speeds are 25 m / sec for pulp
and 12.5 m / sec for paint and putty finish. About
Electronic timers controlled, an in-
vidual pressure beam motion relative to each
continuous workpiece triggered. Bandabstrahl-
provide facilities for continuous blowing out-
sen the sanding belts.

Top and bottom mounted Abbürsteinrichtungen
Clean the polished surfaces by sanding
dust.

Technical data:
-----------------
Sanding width 1350 mm
Drive power per slip band 16,5 / 21 kW
Abrasive Belt dimensions 150 x 7500 mm
Voltage 380 volts, 50 Hz
Total power 90 kW

Transport dimensions
Length 5100 mm
Width 2200 mm
Height 2100 mm
Weight 5500 k